国产高清精品亚洲一区二区三区_国产AV无码一区二区三区日韩_香焦一区二区三区在线现看_特级毛片久久精品_国产一区二区三区野外_天天躁日日躁狠狠躁无码_国产毛片精品大全_亚洲成在人网站无码天堂_啊灬啊灬啊灬快高潮视频_精品中文白虎无码

型號

包裝規格

每箱數量

產品代號

PRODUCT DESCRIPTION

Permatex Anaerobic Gasket Maker is a single component,

medium strength, thixotropic, anaerobic sealant that cures

rapidly. The product cures when confined in the absence

of air between close fitting aluminum surfaces. It provides

a tough, resilient, solvent and temperature resistant seal

that flexes with flange movement caused by vibration,

pressurization or thermal changes. NSF White Book regist

ered.

PRODUCT BENEFITS

● No mixing

● No curing outside of joint

● Non-corrosive to aluminum or cast iron parts

TYPICAL APPLICATIONS

Used for sealing flexible metal machined assemblies

Typically used as a form-in-place gasket on rigid flanged

connections ,e.g Gearbox and engine castings.

DIRECTIONS FOR USE

1.Surfaces to be sealed should be free of grease, oil and dirt.

   Use Permatex Brake and Parts Cleaner to remove oil. Use

   Permatex Gasket Remover to remove old gaskets.

2.Apply manually to one side of flange, making sure a contin

   uous bead is applied.

3.Assemble parts.

4.Torque to normal specifications.

5.Parts may be returned to service in one hour.

For Cleanup

1.Wipe off excess material with a clean cloth

2.Clean hands with Permatex Fast Orange hand cleaner or

   soap and water.

For Cleanup

1.For smaller assembled parts, heat part to 400℉to 450℉。

2.Use cautious, light prying or tapping motion to loosen the

   parts. Repeat heating/prying sequence as needed.

3.For larger assembled parts use prying/cleaving tools in

   combination with a light hammer and cautiously tap and

   pry the sides of the part to break the gasketed surfaces

   loose.

4.Once parts are disassembled, allow all surfaces to cool to

   room temperature.

5.Use Permatex Gasket Remover to remove dried anaerobic

  material.

PHYSICAL PROPERTIES

                                         Typical Value

Chemical Type               Dimethacrylate Ester

Appearance                            Gel

Color                                       Red

Odor                                       Acrid

Specific Gravity                         1.13

Viscosity CP                      750,000/3,750,000Thixotropic

Gap cure (inch)                  0.010 diametral(Unprimed)

                                           0.050 diametral (Primed)

Cure Speed(Hours)                       4-24(Unprimed)

                                              30 Minutes-4(Primed)

Flash Point（℉）                            >200